Fi2000 Tuning issue

576 Views 3 Replies 3 Participants Last post by Whiskey, 9 mo ago

SBC5005

Discussion Starter · Nov 6, 2020

Hi all,
I recently put a set of Cobra Streetrod Slashdowns on my 2005 Boulevard C50. I also installed the fi2000r fuel tuner. I have a stock intake and filter but am looking at a K&N. I was wondering what the best settings would be for the pots. The only thing that concerned me is when the bike is idling, only the red LED on the tuner is lit when the manual says it is supposed to be the green one. When you give it throttle and back off to idle again, it goes to green for a split second then back to red. It idles slowly and like it is being chocked down and near stalling. Any ideas would be greatly appreciated.

Save

1 - 4 of 4 Posts

SBC5005

Discussion Starter · #2 · Nov 6, 2020

SBC5005 said:
Hi all,
I recently put a set of Cobra Streetrod Slashdowns on my 2005 Boulevard C50. I also installed the fi2000r fuel tuner. I have a stock intake and filter but am looking at a K&N. I was wondering what the best settings would be for the pots. The only thing that concerned me is when the bike is idling, only the red LED on the tuner is lit when the manual says it is supposed to be the green one. When you give it throttle and back off to idle again, it goes to green for a split second then back to red. It idles slowly and like it is being chocked down and near stalling. Any ideas would be greatly appreciated.

I forgot to add that I never changed or flipped the exhaust gaskets but the bike only has 1700 miles.

Save

Tappakeg

· #3 · 9 mo ago

SBC5005 said:
I forgot to add that I never changed or flipped the exhaust gaskets but the bike only has 1700 miles.

Have you ever figured out the settings I have the same problem

Save

Whiskey

· #4 · 9 mo ago

Tappakeg said:
Have you ever figured out the settings I have the same problem

Welcome from Kennesaw GA!

I'm afraid the OP hasn't been back on since January. I don't know anything about the tuner. Have you tried contacting the manufacturer of it for help, or checking their website? They usually have default mappings they are happy to provide.

Save

1 - 4 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month