Suzuki Volusia Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
8,384 Posts
Discussion Starter #1
5 1/2" rise and 2 1/2" pull back (actual measurements) with stainless steel washer/spacer for the HD lip on the bottom and bolts. Just barely touches speedo housing when turned lock to lock. Hasn't left any mark on mine after about 2 years of use. A couple of pics of the bike in my gallery (no close-ups).

Not perfect chrome. Some minor chipping/corrosion on the bottom (hard to see when installed). $20 plus shipping. I'll use the date/time stamp on replies to this thread if there is a lot of interest in this item (to determine pecking order). Thanks
 

·
Registered
Joined
·
12,595 Posts
How much height does the washers add to the risers? If you add more washers would it clear the speedo?
 

·
Banned
Joined
·
19,530 Posts
7/8" washer to fill in the gap.
then 1/2" washer under that.
it contacted the speedo housing, but just barely and only when parked at full left.

you can add jim spacers to avoid contacting of the speedo.

 

·
Registered
Joined
·
8,384 Posts
Discussion Starter #6
Thanks for the pics VolRider. The washers that I have add 1/4"to the height of the risers.
 

·
Registered
Joined
·
8,384 Posts
Discussion Starter #7
Re: risers

EfotNamVet said:
I am interested...do you have pay pal?
Yes, I have PayPal. If you want them just PM me with your address and I will give you the info.
 

·
Registered
Joined
·
8,384 Posts
Discussion Starter #8
Sale pending.................
 

·
Registered
Joined
·
8,384 Posts
Discussion Starter #9
SOLD and shipped. You should get them on the 8th. PM'd you the tracking #.
 
1 - 10 of 10 Posts
Top