Suzuki Volusia Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
211 Posts
Discussion Starter · #1 ·
I want to know what are normal cam measurment spec. my bike have 50k miles and I am going to pull engine out and replace timing chains. I plan to measure the cams to see if it's within the spec or needing replacing.

I ordered pair of rear and front timing chains from Webike (japan). Price are reasonable. Received it in about week or week and half (I was gone on 1 1/2 week vacation).

Let me know

Thanks!
 

·
Registered
Joined
·
20,762 Posts
The cam shaft should measure between .9826-.9835" on the journal side and .7858-.7866" on the opposite side. The service limit on the run-out is .004"
 
  • Wow
Reactions: beezer
1 - 3 of 3 Posts
Top