Suzuki Volusia Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hey all,,,I installed a set of Barons 4 inch kickbacks today, and was just wondering what configuration of washers you used, I put one large one on the bottom with the Nylock nut, and on the top I put the rubber grommet, and then the riser on top of that with no washer, as it seems the riser sits on the metal sleeve inside the bushing anyway.
Thoughts?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top