|Topic Review (Newest First)|
|07-27-2018 07:33 PM|
My bike (2012 C50T) was 5 mph fast the day I bought it. With the DJ installed it is still 5 mph fast.
|07-27-2018 12:58 PM|
|Chedell||No, It's based on the rotation of the front wheel.|
|07-27-2018 11:50 AM|
To answer the following question.
Does the DJ Drive mod affect speedometer accuracy?
My 2007 C50's speedometer has always been very accurate. Same speed as others riding with me. Always close to those roadside speed digital readouts.
After my DJ Drive mod it felt like everybody was driving faster. So I ran a test against a GPS speedometer app.
Here are my results:
GPS App Speedometer
Not really interested in going over 80 mph
So on my bike the answer is yes but only noticeable above 50 mph.
|07-24-2017 11:03 AM|
hello dear - i am very glad to hear from you
Well - i allready have bought a VS 1400 Drive shaft.
BTW - w hat ab out the tires - can i swap them to bitgger ones !?
which one are the tallesT
love to hear from you
|07-23-2017 10:01 AM|
Originally Posted by sayhello View Post
You need to change the rear drive hub. The drive shaft is necessary to accommodate the new rear drive. Acquire a C90 type rear drive. The drive shaft will need to be mechanically altered to fit the shorter length spacing between the drive and ujoint assembly.
|07-23-2017 09:52 AM|
hello dear all - i run a VX 800 and i want to make most of it - regarding the gearing.
note: i want to have the tallest 5 Gear ever thinkable!?
What can i do
note - i allready have bought a 1400 drive shaft.
I want to change the rear tire
what else can i do!?
love to hear from you
|06-06-2017 12:11 PM|
|mpillow||Does anyone know of a mod for a C90 to lower rev's at higher speeds (6 speed transmission or different rear end)...|
|04-30-2017 05:32 PM|
Originally Posted by Psyc0 View Post
|04-19-2017 08:18 PM|
This member below regularly sells completed units, and there's a couple other members who also do this.
Poke around the Swap Meet forum to find the others.
|04-19-2017 04:17 PM|
So I'm about to likely dig in to this on my girlfriend's '07 C50. Sounds like her splines went and will be checking this Saturday. Either way, we'll have it all out and she wants to do the upgrade anyhow. I'll hope over to the swap meet to look for drop-ins first. If nothing, I can likely handle the build since I have a few friends who are machinist. If not, anyone know if any of the people who did the drop-ins still do? I already sent an email to the one provided.
|This thread has more than 10 replies. Click here to review the whole thread.|